BATTERY CHARGER MODULE CABUR

BATTERY CHARGER MODULE " CABUR" FOR POWER SUPPLY 1-10A MODEL : CSBC P/ N : XCSBC Accessory for charging buffer batteries • Battery charger • Allows to connect in redundant parallel two power supplies • Suitable for power supplies up to 10 A • Battery protection fuse • Battery feedback protection diode • Current charge limiting resistor VERSIONS Cod. XCSBC CSBC GENERAL TECHNICAL DATA Power supply rated voltage 6...30 Vdc Power supply rated current > 3 A Load rated voltage 6...29.5 Vdc Load max current 10 A Charge current limitation ( 1) Battery disconnecting voltage not available IN/ OUT drop voltage 0.5 V Battery protection fuse F1 = T 6.3 A / F2 = T 1 A Protections battery short circuit / overload ( 2) Alarm signal — Operating temperature range – 10...+ 50° C Reference Standards IEC 664-1, DIN VDE Overvoltage category/ Pollution degree II / 2 Protection degree IP 20 IEC 529, EN60529 Connection terminal 2.5 mm² fixed screw type Housing material UL94V-0 plastic material Approx. weight 80 g ( 2.82 oz) Mounting information vertical on rail, adjacent MOUNTING ACCESSORIES Mounting rail type according to IEC60715/ TH35-7.5 PR/ 3/ AC, PR/ 3/ AC/ ZB, PR/ 3/ AS, PR/ 3/ AS/ ZB Mounting rail type according to IEC60715/ G32 PR/ DIN/ AC, PR/ DIN/ AS, PR/ DIN/ AL APPLICATIONS The depth dimension includes the terminal blocks and the DIN rail clamp. ( 1) The charging current is dependent on the battery type and the required level of charge, it' s about: - 0, 5A max @ 12Vdc battery - 1A max @ 24Vdc battery ( 2) The device do not avoid total discharge which always shortens battery life. 1. Battery charger With this module is possible to use a Cabur power supply as a battery charger while it is feeding the load. The diode provides decoupling between the battery and the power supply; the resistance limits the current charge limiting power supply output current and assuring longer life to the battery. The F1 fuse protects the battery and its wiring against short circuit. The next picture shows the connections. 2. Parallel connection of power supplies It is possible to use this module also to connect two power supplies in parallel, not provided with output decoupling diode, eliminating “ Fuse 2” in series to charging current limiting resistor. The next picture shows the connections.